________________________________________
From: Li, Haixia
Sent: Tuesday, November 17, 2009 4:24 PM
To: milos rovcanin
Subject: RE: [Tinyos-help] sensor problem
Hello,
First, I need to tell you I don't know it very clearly, but it works. I will
tell you what I did. I hope it can help you.
Does the O2 sensor need a ADC channel? If it does, you can change
PhotoTempConfigC where the channel is defined.
//-----------------
PhotoTempConfigP.PhotoTempAdc -> MicaBusC.Adc1; //this assigns the
Adc1. You can change it according your requirement
Does the O2 sensor need a excitation? If it does, you can change PhotoImplP .
//-----------------------
SharedAnalogDeviceC.EnablePin -> MicaBusC.Int3; the voltage is 2.5V,
almost 25ms. You can check it.
If your sensor needs another excitation, you might need to change another
components.
Good luck.
Best regards,
Haixia Li
________________________________________
From: milos rovcanin [[email protected]]
Sent: Tuesday, November 17, 2009 1:48 PM
To: Li, Haixia
Subject: Re: [Tinyos-help] sensor problem
Can you tell me what modifications have you done on the PhotoImplP and why?
PLease, I need a hint! I am trying to connect an O2 sensor to a node over
MDA100 sensor board...
Thanks!
--
Best regards,
Milos Rovcanin
_______________________________________________
Tinyos-help mailing list
[email protected]
https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
