You should be able to connect the analog output to any available ADC pin. ADC3-7 seem to be available on the prototyping pads, however ADC7 is also used internally to read the Battery reference.
From my brief reading of the sensor specs, if you have the EC-5 you can run it from the same battery power as the iris. But with any of them the max output you get is 40% of the supply voltage, so your conversion range is somewhat limited. Running an EC-10 on 5v would boost that range a bit, but then you need another power supply...and another sensor... You can probably modify the DemoSensor module to read from the ADC you select. That module is used in most of the demo apps, in TOS-1.x at least... MS George_1985 wrote: > Hi guys i have allready MIB520, iris motes , MDA100CB developemnt area and > soil moisture senros EC-5 from Decagon. > > I have put the MDA100CB on iris (with 51-pins). > > So i want to connect the soil moisture sensor in MDA100CB and send data to > iris and then to the MIB520 board. > > Ηοw have to connect the cable's soil to MDA100CB? Here is the manual's soil > http://www.decagon.com/assets/Manuals/EC-20-EC-10-EC-5-Soil-Moisture-Sensor-User-Manual.pdf > . > > It has three wires Analog out , Ground , Excitation. > > Thank you _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
