Hi all, I'm using the SHT11 sensor to get some temperature readings. The values I am getting are quite large (at least 3-4 degrees higher). I was thinking this may be due to the on-chip heater being activated.
I tried to turn off / on the heater using the HalSht11Advanced interface, but no difference. I started reading the value of the status register of the Sht11 after the change, but it always comes up as 0x07. I noticed that in the Sht11 driver, the readStatusReg and the writeStatusReg are labelled as "FIXME", "don't seem to work". Has anyone else had any experience with this? Is the code working or not? Regards, Victor
_______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
