> Hi all, > > I'm using the SHT11 sensor to get some temperature readings. The values I > am getting are quite large (at least 3-4 degrees higher). I was thinking > this may be due to the on-chip heater being activated.
Are you powering the device by USB? Try with batteries. Markus > I tried to turn off / on the heater using the HalSht11Advanced interface, > but no difference. > I started reading the value of the status register of the Sht11 after the > change, but it always comes up as 0x07. > > I noticed that in the Sht11 driver, the readStatusReg and the > writeStatusReg are labelled as "FIXME", "don't seem to work". > > Has anyone else had any experience with this? Is the code working or not? > > Regards, > Victor _______________________________________________ Tinyos-help mailing list [email protected] https://www.millennium.berkeley.edu/cgi-bin/mailman/listinfo/tinyos-help
