Re: Topband: Silver solder

[Paul Christensen]

> “If you had trouble with an oxyacetylene torch, then I'll bet you used 
> "silver-bearing" (tin-copper-silver) solder, which melts at well under 700 
> degrees. 
These are mid-level silver sticks with 15% silver + copper/phosphor and have a 
working temperature of 1200-1400 degs. F – but not the 2-5% silver bearing 
variety with a lower melting point.  You are probably using a much higher 
silver content if working with OxyAcet.  
Using OxyAcet on the 15% bars can quickly result in boiling and vaporizing of 
the solder with damage done to the copper, especially to a copper strap.  With 
15% bars, Acetylene/air works fine even with a high amount of heat-sinking.  I 
have not yet tried MAPP gas.
Paul, W9AC
_________________
Topband Reflector Archives - http://www.contesting.com/_topband