Gazjam;578355 Wrote: 
> thanks John, good info as always.
> 
> Need to check up WHICH usb implementation my Caiman has...
> I dont have a lot of 24/96 stuff, so might be worth investigating as a
> possible tweak.
> 
> Whats the "good" usb implementation to look for John?
> (I can probably ask the Dac designer direct on another forum..)
> 
> Sorry!

John?(or other USB experts?)
Can I bother you to scan your eye over this please, just a general
recommendation if you would?

The USB chip in my Dac is THIS one:
PCM2902E

Specs:

SINGLE-ENDED ANALOG INPUT/OUTPUT AND S/PDIF
– Pass-Band Ripple = ±0.1 dB
234· PCM2900: Without S/PDIF – Stop-Band Attenuation = –43
dB
· PCM2902: With S/PDIF – Single-Ended Voltage Output
· On-Chip USB Interface: – Analog LPF Included
– With Full-Speed Transceivers · Multifunctions:
– Fully Compliant With USB 1.1 Specification – Human
Interface Device (HID) Volume ±
– Certified by USB-IF Control and Mute Control
– Partially Programmable Descriptors (1) – Suspend Flag
– USB Adaptive Mode for Playback · Package: 28-Pin SSOP
– USB Asynchronous Mode for Record
– Bus Powered · USB Audio Speaker
· 16-Bit Delta-Sigma ADC and DAC · USB Headset
· Sampling Rate: · USB Monitor
– DAC: 32, 44.1, 48 kHz · USB Audio Interface Box
– ADC: 8, 11.025, 16, 22.05, 32, 44.1, 48 kHz
· On-Chip Clock Generator With Single 12-MHz
Clock Source The PCM2900/2902 is Texas Instruments' single-chip
· Single Power Supply: 5 V Typical (VBUS) USB stereo audio codec with
USB-compliant
· Stereo ADC full-speed protocol controller and S/PDIF . The USB
protocol controller works with
– Analog Performance at VBUS = 5 V no software code, but the USB
descriptors can be
– THD+N = 0.01% modified in some areas (e.g., vendor ID/product
ID).
– SNR = 89 dB The PCM2900/2902 employs SpAct™ architecture,
– Dynamic Range = 89 dB TI's unique system that recovers the
audio clock from USB packet data. On-chip analog PLLs with SpAct
– Decimation Digital Filter architecture enable playback and
record with low
– Pass-Band Ripple = ±0.05 dB clock jitter and with independent
playback and record
– Stop-Band Attenuation = 65 dB sampling rates.
– Single-Ended Voltage Input
– Antialiasing Filter Included
– Digital LCF Included
· Stereo DAC
– Analog Performance at VBUS = 5 V
– THD+N = 0.005%
– SNR = 96 dB
– Dynamic Range = 93 dB
– Oversampling Digital Filter

http://nl.mouser.com/Search/ProductDetail.aspx?qs=wgAEGBTxy7mJPSH2QDmALg==

Thanks!


-- 
Gazjam
------------------------------------------------------------------------
Gazjam's Profile: http://forums.slimdevices.com/member.php?userid=18604
View this thread: http://forums.slimdevices.com/showthread.php?t=82110

_______________________________________________
Touch mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/touch

Reply via email to