I use Category 6 Enhanced 550 MHz TIA/EIA 568B.2 UTP Unshielded Twisted Pair which supports Gigabit connections. I did not want to run ethernet cable that lacked capacity in a few years. For short runs that aren't in walls or attics (ugh!) CAt 5 is fine. As long as shielding is avoided as that leads to groundloop hum. Only use UTP. The SB3, when used with a wired connection sounded so much better because you could configure it not to power up the wlan card and therefore no radio interference affecting sound quality. With the Touch Soundcheck's SW mods are needed to keep the wlan card from powering up at boot. You can't really make a choice about this until you get rid of the noise from the wireless.
-- lcrim ------------------------------------------------------------------------ lcrim's Profile: http://forums.slimdevices.com/member.php?userid=1626 View this thread: http://forums.slimdevices.com/showthread.php?t=82269 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
