Interesting concept, currently they are cut out using a laser cuter rather than a 3d printer which is going to be more expensive as it will have to be developed further and the general process is more complex i belive so will likely push up costs.
tbh i have no idea if it would break if you try and pull it of the wall, the trick will be to use the minimum amount of tape necessary to get a hold. I highly reccomend that people take of the stand using a torx screwdriver as you will be surprised to find how much that weighs. with the stand removed it is very light and I expect it just to need a piece at each corner (on straight walls) which will make it much easier to get a knife in there to try and get it off. I'm more just trying to set expectations, this is not a rigorously tested product meant for the mass market. ------------------------------------------------------------------------ trouty00's Profile: http://forums.slimdevices.com/member.php?userid=30875 View this thread: http://forums.slimdevices.com/showthread.php?t=95114 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
