kimchee411 wrote: > Is it possible to change the sample rate with EDO? I just got a > Wavelength Wavelink HS and it is detected by the Touch, but the problem > is that my MHDT Havana DAC only supports up to 24/96. The Wavelink > ALWAYS shows a 192KHz signal when connected to the Touch, no matter what > is playing -- even nothing at all -- and the DAC does not show a > connected signal. Same goes for my Metrum Octave DAC. > > I tried the Wavelink on my Mac Mini and when I set the Wavelink to > 192KHz or 176.6KHz in Audio Midi I get the same results and the > Wavelink's LED shows the correct sampling rate changes. If I set it to > 96 or below it works, so looks like the Touch is always upsampling to > 192... at least with the Wavelink.
NEVERMIND! Turns out the Wavelink was NOT properly detected. It showed up in /proc/asound/cards as card3 and I was able to select the device in EDO, but it was not showing up in "aplay -l" and device status in EDO/stream0 showed "stopped". Did some digging in this thread and found Triode's instructions to try test kernel #7 so I installed that and it works! The Wavelink shows up in aplay -l (now card1 as only spdif and USB are enabled with test kernel 7), stream0 now shows "running", and the correct sampling rate of whatever's playing lights up on the Wavelink. AWESOME -- THANKS TRIODE! ------------------------------------------------------------------------ kimchee411's Profile: http://forums.slimdevices.com/member.php?userid=51401 View this thread: http://forums.slimdevices.com/showthread.php?t=94512 _______________________________________________ Touch mailing list [email protected] http://lists.slimdevices.com/mailman/listinfo/touch
