Yes, I am/was missing something. There are TWO commands CONFIG sets the profile to MODIFY, PROFILE sets the configuration to USE. I wonder how many others missed this distinction....
-- In [email protected], "EM Sharp" <wa2...@...> wrote: > > I wonder if I am missing something. It seems to me that there is no way to > disable profile switching or change enable/disable parameters in command > mode. Wouldn't it be nice if Prof 0 set the T2 into "use switching > parameters" mode, PROF 1 would disable parameter controlled switching and put > the unit in Profile 1, PROF 2 would make Profile 2 active and allow editing. > When all the desired editing is complete, PROF 0 would reactivate parameter > controlled switching. At least this would allow editing of the COM text in > each profile without having to do it while a vehicle is moving at 20+ miles > per hour if Profile 1 is set to be active when Speed is <5 mph and the T2 > switches to Profile 2 when the Speed is >15 mph. Many other situations exist > where a parameter change from command mode would be nice. I think, also, that > several commands to set parameters in command mode are missing and the unit > has to be taken back to OTCONFIG to set the values. Perhaps a review of this > whole subject is in order. >
