Ok, could be a bad solder joint on the 10m resistor, or maybe just a bad crystal. I'll get a new one out to you Tuesday.
Scott n3ujj wrote: > > > > Scott, > > While "touching around", at one point, it flickered from red then back > to green. > > Could not get it to duplicate.... > > Scott > > --- In [email protected] <mailto:tracker2%40yahoogroups.com>, > Scott Miller <sc...@...> wrote: > > > > Try touching the board around the crystal while it's turned on, see if > > the LEDs change. I can exchange it on Tuesday if you don't find > > anything obvious wrong with it. > > > > Scott > > > > n3ujj wrote: > > > > > > > > > Scott, > > > > > > Lights up, when TNC activated, never blinks, not even during powerup, > > > > > > Solid on, anything I can check to give you more info? > > > > > > Scott (n3ujj) > > > > > > --- In [email protected] <mailto:tracker2%40yahoogroups.com> > <mailto:tracker2%40yahoogroups.com>, > > > Scott Miller <scott@> wrote: > > > > > > > > Is it lit continuously, or does it just blink? > > > > > > > > Scott > > > > > > > > n3ujj wrote: > > > > > > > > > > > > > > > > > > > > Scott, > > > > > > > > > > When looking at the board under magnifier, I notice it's LED1 that > > > > > light's gren (it's marked "red", LED 2 (marked grn) does not light > > > > > > > > > > Crystal is not shorted > > > > > > > > > > Scott (n3ujj) > > > > > > > > > > --- In [email protected] > <mailto:tracker2%40yahoogroups.com> <mailto:tracker2%40yahoogroups.com> > > > <mailto:tracker2%40yahoogroups.com>, > > > > > > > > > >
