Never mind. I was going through the junk box and found a 12DC 400ma wall wart. Plugged it in and the leds blinked. Connected to the computer and all is well. Although the label indicates 7 to 28 volts the 9 volt wall wart wouldn't do the trick. Sorry for the QRM on the forum
Neal - WD4LSS --- In [email protected], "pruittn2" <n5...@...> wrote: > > I have a T2 that will not connect to the computer. I have verified that the > null modem cable is good and pins 2 & 3 crossover from one end to the other. > I have performed a loopback test on the serial port to verify it is good. > When I power up the the T2 the RX led glows faintly and continuously. There > is no initial blink of any of the leds as described in some other posts. I > am powering the T2 with a 9VDC 300ma wall wart. Any ideas on what to try or > check next? >
