Hi Randy, Thanks again for the reply. Well, basically I would need to set as below:
Port A -> Command/Console mode Port B -> NMEA mode In OTWINCFG, there is neither any option for Command nor NMEA. I was tempted to put both port A and B into auto mode, but the manual has advised that only one port should be in AUTO mode and not both. Are there any other ways to work around this issue? I have no problem swapping the GPS and PC between ports A and B. 73, Sion Chow Q. C., 9W2QC, WQ2C Quoting Randy Love <[email protected]>: > sorry. I just saw that you were asking about NMEA specifically. > just set it to AUTO and it will recognize a gps putting out NMEA > automatically. > don't forget to set your gps to put out NMEA :) > > Randy > WF5X > > > On Sat, Dec 12, 2009 at 2:04 PM, Randy Love <[email protected]> wrote: >> On Sat, Dec 12, 2009 at 1:25 PM, Sion Chow Q. C. (9W2QC) <[email protected]> >> wrote: >>> >>> However, how do I set Port B to NMEA. OTWINCFG >>> >>> does not seem to have this setting. >>> >> open OTWINCFG >> on the right side, there is a group box called "Serial Ports" >> in that group box are dropdown lists for "Baud Rate" and "Mode" >> top 2 are for portA and bottom 2 are for port B >> Set according to recommendations in previous post >> >> 73, >> Randy >> WF5X >> >> >> > > > ------------------------------------ > > Yahoo! Groups Links > > > >
