I can't remember in the config if you can get the
altitude into a status packet (I think you can).
You can read status messages on the T2/Nuvi350
Mark
KC5EVE
At 02:45 PM 1/22/2010, you wrote:
I sent the message below yesterday but haven't
seen it come across the Yahoo Group(s). Perhaps
it was lost. I originally had high-jacked
another thread with this and apologize for
that. I would, however, like to figure out a
way to see my balloon flights altitude on my Nuvi.
PL
++++++++++++++++++++
I run a Kenwood TH-G71 HT with a Garmin 18 and
an OT+ on high altitude balloon flights. Using
my T2-135 in the Alinco 2 meter mobile connected
to a Garmin Nuvi 350 I cannot see an altitude
display on the Nuvi. I would like to be able to
extract that info while chasing the balloon for recovery.
Is there some way I can either pull that info
via the Nuvi or change some setting in the OT+
so that it does display altitude?
The OT+ is just a few months old.
Pete
KC0GPB
