That just might work. I'll try that. Thanks, Mark! Pete KC0GPB
On Fri, Jan 22, 2010 at 4:02 PM, Mark Cheavens <[email protected]> wrote: > > > I can't remember in the config if you can get the altitude into a status > packet (I think you can). > > You can read status messages on the T2/Nuvi350 > > Mark > KC5EVE > > At 02:45 PM 1/22/2010, you wrote: > > > > I sent the message below yesterday but haven't seen it come across the > Yahoo Group(s). Perhaps it was lost. I originally had high-jacked another > thread with this and apologize for that. I would, however, like to figure > out a way to see my balloon flights altitude on my Nuvi. > > PL > > ++++++++++++++++++++ > > I run a Kenwood TH-G71 HT with a Garmin 18 and an OT+ on high altitude > balloon flights. Using my T2-135 in the Alinco 2 meter mobile connected to > a Garmin Nuvi 350 I cannot see an altitude display on the Nuvi. I would > like to be able to extract that info while chasing the balloon for recovery. > > Is there some way I can either pull that info via the Nuvi or change some > setting in the OT+ so that it does display altitude? > > The OT+ is just a few months old. > > Pete > KC0GPB > > >
