I apologize if the subject has been covered recently.. Can anyone summarize the applicable rules and standards for the part of a circuit that will connect to a T1/E1 line?
My board, almost ready to build, connects to a T1 line directly using a transformer coupled interface. I've never done T1 before and don't know for sure what protection, spacing applies. My connector is an RJ-48. Examples would be welcome, a consultant would be grudgingly considered. Dan Falkoff email: [email protected] employer: NetPhone Inc. ..makers of the NetPhone PBX-on-a-card www.netphone.com phone: (508) 787-1000 Ext 204 FAX: (508) 787-1030
