Ok somebody gave me the way I should edit the initrd.gz:
First boot Trinux. Don't load any data disk or package.
dd if=/dev/zero of=/dev/ram5 bs=1k count=4096
mount /dev/fd0 /mnt Use "mount /dev/hda1 /mnt" in TrinuxHD.
cp /mnt/initrd.gz /usr Use "cp /mnt/trinux/initrd.gz /usr" in TrinuxHD.
gzip -d /usr/initrd.gz
dd if=/usr/initrd of=/dev/ram5 bs=1k
IMPORTANT: Write down now the number of blocks copied!
rm /usr/initrd.gz
mkdir /usr/init
mount /dev/ram5 /usr/init
Now you have the original initrd filesystem in /usr/init.
Make changes to linuxrc or whatever. Below two lines are examples.
vi /usr/init/linuxrc
echo "modules parameters" > /usr/init/etc/conf.modules
Change finished. Now complete operation.
umount /usr/init
dd if=/dev/ram5 of=/usr/initrd bs=1k
count=Put_here_number_of_blocks_written_down_before
gzip -9 /usr/initrd
cp /usr/initrd.gz /mnt Use "cp /usr/initrd.gz /mnt/trinux" in TrinuxHD.
umount /mnt
Problem is that I can't even run the first line:
I just get an Usage overview which specifies only two option:
bs=BYTES
count=BLOCKS
Can somebody tell me what I'm missing???
Thanx again.
Jordi Haarman
mailto:[EMAIL PROTECTED]
------------------------------------------------------------------------------------
www.trinux.org hosted by The Vnode Connector Services
www.vnode.com *** Special Discounts For Trinux Users
*** Email [EMAIL PROTECTED]
------------------------------------------------------------------------------------
