On 2/12/08, Ulf Samuelsson <[EMAIL PROTECTED]> wrote: > > >> > Once I start using sam7 util, the bootstrap code has not been executed > >> > which means the SDRAM has not been initialized. I'll have to added the > >> > lowlevel init to do that, which I might try if nothing else works. > >> > > >> > > >> You don't understand: > >> > >> - flash all arm9load & u-boot > >> - loady <address> u-boot-mod > >> - go <address> > > > > I'm tying this method. I had to go to kermit because I never had > > suscess loading serially with minicom. I had problems with kermit in > > the past but couldn't remember what it was... until now. I've always > > had fatal errors after a few bytes are transmitted. I get some error, > > then it tries to resend but had too many errors. I'm not really sure > > how to get past this as I'm configured the serial line accordingly. > > Is this a common "user error" problem with ckermit? I've double > > checked my config option with uboot docs. > > > > I have used "minicom" a lot when downloading to the AT91RM9200, > but I use the special downloading program which I found somewhere > and included in the U-Boot-1.1.2 found on buildroot.uclibc.org. > > Did you try programming from Windows using SAM-BA?
ckermit will work just fine and I rather stick to my linux system. Linux can do everything windows does... and more. Thanks. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
