Hi Timur, Timur Tabi wrote: > Update the sys_eeprom.c file to handle both NXID and CCID EEPROM formats. The > NXID format replaces the older CCID format, but it's important to support both > since most boards out there still use the CCID format. This change is in > preparation for using one file to handle both formats. This will also unify > EEPROM support for all Freescale 85xx and 86xx boards. > > Also update the 86xx board header files to use the standard > CFG_I2C_EEPROM_ADDR > instead of ID_EEPROM_ADDR. > > Signed-off-by: Timur Tabi <[EMAIL PROTECTED]> > --- > > This patch is the first in a series to clean up the MAC address determination > in some of Freescale's board. The ultimate goal is to get rid of > CONFIG_ETHADDR and related macros in the board header files. > > So are you saying that the plan is to move much of the configuration information from NOR flash to I2C EEPROMs on Freescale evaluation boards? I'm not suggesting that it's a good or bad idea, but just keep in mind that the main raison d'etre for these boards is to serve as starting points for customer designs, and I'm not sure the majority of customers would use things this way.
regards, Ben ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ U-Boot-Users mailing list U-Boot-Users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/u-boot-users
