Hi Ben, The ethernet adapter (PCMCIA ethernet card) which is directly connect to the board can be forced in windows to use 100Mbit full duplex, but u-boot still use 1Gbit. It's a Marvell phy, the exact phy description I have not in mind. The processor is a mpc8313.
We are using a customized board which based on the MPC8313ERDB board. Nevertheless, is there a special env variable to set in U-Boot to use another speed, in this case 100Mbit? (e.g. I can choose by setting "using ethact TSEC1 which tsec should be used) Is there something equivalent for using tsec speed? Regards, Frank -----Ursprüngliche Nachricht----- Von: Ben Warren [mailto:[EMAIL PROTECTED] Gesendet: Mittwoch, 25. Juni 2008 18:34 An: Frank Prepelica Cc: [email protected] Betreff: Re: [U-Boot-Users] Set manually tsec speed in u-boot 1.2.0 Hi Frank, Frank Prepelica wrote: > > Hi all, > > > > is there a way to set the tsec speed in u-boot (v1.2.0) manually to > 100Mbit? Because u-boot always uses 1Gbit although the > > link speed is fixed set(in windows) to 100Mbit. > > > How does Windows fit into this? Are you booting Windows on the board? Are you connecting to a Windows machine via a crossover, via a switch, or something else? What PHY is connected to the TSEC? What processor are you using? regards, Ben ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
