On Fri, Jun 27, 2008 at 2:37 AM, Frank Prepelica <[EMAIL PROTECTED]> wrote: > Hi Ben, > > The ethernet adapter (PCMCIA ethernet card) which is directly connect to the > board can be forced in windows to use 100Mbit full duplex, but u-boot still > use 1Gbit. It's a Marvell phy, the exact phy description I have not in mind. > The processor is a mpc8313. > > We are using a customized board which based on the MPC8313ERDB board. > > Nevertheless, is there a special env variable to set in U-Boot to use another > speed, in this case 100Mbit? (e.g. I can choose by setting "using ethact > TSEC1 which tsec should be used) Is there something equivalent for using tsec > speed?
I don't see any way to set it explicitly, but the default mode is autonegotiate, so the TSEC will run at the highest rate supported by its peer. I plug these things into 10/100 switches all the time and they work fine. What problem are you seeing. regards, Ben ------------------------------------------------------------------------- Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _______________________________________________ U-Boot-Users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/u-boot-users
