Hi Diptopal, I had got a similar problem. So, what I did was, I enabled the low level debugging option in the kernel config. Then when I tried with this new kernel, after the Uncompressin Linux.... line I got a message saying that the kernel was not compatible with the ARM processor I was using, though it worked on the other ARM processors that I had. May be you have the same problem. I am not very sure, but why not give it a try..
Regards, -Piyush On Thu, Dec 25, 2008 at 8:40 PM, Diptopal Basu <[email protected]> wrote: > Hi , > > I have compiled a Linux kernel ( version 2.6.22.19 ) for ARM > at91rm9200dk board, I used the mkimage utility in U boot load the > kernel at a specific area of memory . ( Skyeye Simulator ) > > However I get the Uncompressing Linux ... message and it stays at that > line indefinitely ... > attaching screenshot ... this is on the skyeye simulator . > > > I am just booting the kernel I do not have a device tree blob or > anything else here , that is , I compiled the kernel with at91rm9200dk > defconfig, got the zImage , used mkimage to add a U boot header and > using bootm <memory location where the file is flashed > command to > start it . > > > What could be the problem ? > > Regards > Diptopal Basu > > _______________________________________________ > U-Boot mailing list > [email protected] > http://lists.denx.de/mailman/listinfo/u-boot > > -- -PIYUSH _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
