Hi Stephen, On Wed, Jan 16, 2013 at 2:51 PM, Stephen Warren <[email protected]> wrote: > On 01/16/2013 02:14 PM, Tom Warren wrote: >> This build is stripped down. It boots to the command prompt. >> GPIO is the only peripheral supported. Others TBD. > >> diff --git a/board/nvidia/dalmore/dalmore.c b/board/nvidia/dalmore/dalmore.c > >> +void pinmux_init(void) >> +{ >> + pinmux_config_table(tegra3_pinmux_common, >> + ARRAY_SIZE(tegra3_pinmux_common)); > > I assume that should say "tegra114" not "tegra3"? > >> diff --git a/include/configs/dalmore.h b/include/configs/dalmore.h > >> +/* Must be off for Dalmore to boot !?!? FIXME */ >> +#define CONFIG_SYS_DCACHE_OFF > > Who knows if there is any A15 core/cache controller support in U-Boot yet?
Sort-of. It works ok for me on snow, so long as you have a patch to enable L2 support. Regards, Simon > > Aside from any comments I've made, the series, briefly, > Reviewed-by: Stephen Warren <[email protected]> > _______________________________________________ > U-Boot mailing list > [email protected] > http://lists.denx.de/mailman/listinfo/u-boot _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
