Hi Tom, On Tue, Jan 22, 2013 at 12:47 PM, Tom Warren <[email protected]> wrote: > Simon, > > On Mon, Jan 21, 2013 at 4:07 PM, Simon Glass <[email protected]> wrote: >> Hi Stephen, >> >> On Wed, Jan 16, 2013 at 2:51 PM, Stephen Warren <[email protected]> >> wrote: >>> On 01/16/2013 02:14 PM, Tom Warren wrote: >>>> This build is stripped down. It boots to the command prompt. >>>> GPIO is the only peripheral supported. Others TBD. >>> >>>> diff --git a/board/nvidia/dalmore/dalmore.c >>>> b/board/nvidia/dalmore/dalmore.c >>> >>>> +void pinmux_init(void) >>>> +{ >>>> + pinmux_config_table(tegra3_pinmux_common, >>>> + ARRAY_SIZE(tegra3_pinmux_common)); >>> >>> I assume that should say "tegra114" not "tegra3"? >>> >>>> diff --git a/include/configs/dalmore.h b/include/configs/dalmore.h >>> >>>> +/* Must be off for Dalmore to boot !?!? FIXME */ >>>> +#define CONFIG_SYS_DCACHE_OFF >>> >>> Who knows if there is any A15 core/cache controller support in U-Boot yet? >> >> Sort-of. It works ok for me on snow, so long as you have a patch to >> enable L2 support. > > Which patch, exactly, to enable L2 support? I'd like to test it on T114.
I was thinking about this one (it will need porting and perhaps can become partly common?) http://patchwork.ozlabs.org/patch/202874/ Regards, Simon > > Thanks >> >> Regards, >> Simon >> >>> >>> Aside from any comments I've made, the series, briefly, >>> Reviewed-by: Stephen Warren <[email protected]> >>> _______________________________________________ >>> U-Boot mailing list >>> [email protected] >>> http://lists.denx.de/mailman/listinfo/u-boot _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
