On Sat, Jan 26, 2013 at 3:41 AM, Lucas Stach <[email protected]> wrote: > Remove unneeded headers, function prototype and stale comment, that > doesn't match the actual codebase anymore. > > Signed-off-by: Lucas Stach <[email protected]>
Acked-by: Simon Glass <[email protected]> > --- > arch/arm/cpu/armv7/tegra20/usb.c | 13 +------------ > arch/arm/include/asm/arch-tegra20/usb.h | 3 --- > 2 files changed, 1 insertion(+), 15 deletions(-) > > diff --git a/arch/arm/cpu/armv7/tegra20/usb.c > b/arch/arm/cpu/armv7/tegra20/usb.c > index e4165e0..3fdd5df 100644 > --- a/arch/arm/cpu/armv7/tegra20/usb.c > +++ b/arch/arm/cpu/armv7/tegra20/usb.c > @@ -25,21 +25,15 @@ > #include <asm/io.h> > #include <asm-generic/gpio.h> > #include <asm/arch/clock.h> > -#include <asm/arch/gpio.h> > -#include <asm/arch/pinmux.h> > -#include <asm/arch/tegra.h> > #include <asm/arch/usb.h> > #include <usb/ulpi.h> > -#include <asm/arch-tegra/clk_rst.h> > -#include <asm/arch-tegra/sys_proto.h> > -#include <asm/arch-tegra/uart.h> > #include <libfdt.h> > #include <fdtdec.h> > > #ifdef CONFIG_USB_ULPI > #ifndef CONFIG_USB_ULPI_VIEWPORT > #error "To use CONFIG_USB_ULPI on Tegra Boards you have to also \ > - define CONFIG_USB_ULPI_VIEWPORT" > + define CONFIG_USB_ULPI_VIEWPORT" > #endif > #endif > > @@ -191,11 +185,6 @@ void usbf_reset_controller(struct fdt_usb *config, > struct usb_ctlr *usbctlr) > /* Enable the UTMIP PHY */ > if (config->utmi) > setbits_le32(&usbctlr->susp_ctrl, UTMIP_PHY_ENB); > - > - /* > - * TODO: where do we take the USB1 out of reset? The old code would > - * take USB3 out of reset, but not USB1. This code doesn't do either. > - */ > } > > /* set up the UTMI USB controller with the parameters provided */ > diff --git a/arch/arm/include/asm/arch-tegra20/usb.h > b/arch/arm/include/asm/arch-tegra20/usb.h > index fdbd127..b18c850 100644 > --- a/arch/arm/include/asm/arch-tegra20/usb.h > +++ b/arch/arm/include/asm/arch-tegra20/usb.h > @@ -243,9 +243,6 @@ struct usb_ctlr { > #define VBUS_VLD_STS (1 << 26) > > > -/* Change the USB host port into host mode */ > -void usb_set_host_mode(void); > - > /* Setup USB on the board */ > int board_usb_init(const void *blob); > > -- > 1.8.0.2 > _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
