[U-Boot] [PATCH v2 12/15] net: gem: Add support for phy autodetection

[Michal Simek]

Autodetect phy if phyaddress is setup to -1.

Signed-off-by: Michal Simek <michal.si...@xilinx.com>
---
Changes in v2: None

 drivers/net/zynq_gem.c | 51 ++++++++++++++++++++++++++++++++++++++++++++++++++
 1 file changed, 51 insertions(+)

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index 8e0e01c..eac9b6f 100644
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -95,6 +95,17 @@
                                        ZYNQ_GEM_DMACR_TXSIZE | \
                                        ZYNQ_GEM_DMACR_RXBUF)

+/* Use MII register 1 (MII status register) to detect PHY */
+#define PHY_DETECT_REG  1
+
+/* Mask used to verify certain PHY features (or register contents)
+ * in the register above:
+ *  0x1000: 10Mbps full duplex support
+ *  0x0800: 10Mbps half duplex support
+ *  0x0008: Auto-negotiation support
+ */
+#define PHY_DETECT_MASK 0x1808
+
 /* Device registers */
 struct zynq_gem_regs {
        u32 nwctrl; /* Network Control reg */
@@ -201,6 +212,44 @@ static u32 phywrite(struct eth_device *dev, u32 phy_addr, 
u32 regnum, u16 data)
                                ZYNQ_GEM_PHYMNTNC_OP_W_MASK, &data);
 }

+static void phy_detection(struct eth_device *dev)
+{
+       int i;
+       u16 phyreg;
+       struct zynq_gem_priv *priv = dev->priv;
+
+       if (priv->phyaddr != -1) {
+               phyread(dev, priv->phyaddr, PHY_DETECT_REG, &phyreg);
+               if ((phyreg != 0xFFFF) &&
+                   ((phyreg & PHY_DETECT_MASK) == PHY_DETECT_MASK)) {
+                       /* Found a valid PHY address */
+                       debug("Default phy address %d is valid\n",
+                             priv->phyaddr);
+                       return;
+               } else {
+                       debug("PHY address is not setup correctly %d\n",
+                             priv->phyaddr);
+                       priv->phyaddr = -1;
+               }
+       }
+
+       debug("detecting phy address\n");
+       if (priv->phyaddr == -1) {
+               /* detect the PHY address */
+               for (i = 31; i >= 0; i--) {
+                       phyread(dev, i, PHY_DETECT_REG, &phyreg);
+                       if ((phyreg != 0xFFFF) &&
+                           ((phyreg & PHY_DETECT_MASK) == PHY_DETECT_MASK)) {
+                               /* Found a valid PHY address */
+                               priv->phyaddr = i;
+                               debug("Found valid phy address, %d\n", i);
+                               return;
+                       }
+               }
+       }
+       printf("PHY is not detected\n");
+}
+
 static int zynq_gem_setup_mac(struct eth_device *dev)
 {
        u32 i, macaddrlow, macaddrhigh;
@@ -290,6 +339,8 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis)
                priv->init++;
        }

+       phy_detection(dev);
+
        /* interface - look at tsec */
        phydev = phy_connect(priv->bus, priv->phyaddr, dev, 0);

--
1.8.2.1

pgprUD87gLYaA.pgp
Description: PGP signature

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot