Signed-off-by: Heiko Schocher <[email protected]>
---
- changes for v2:
defined all bits used in the gmii_sel register as
Tom Rini suggested
- changes for v3:
rebased against u-boot-ti commit bb2a5d8f87fffb4fadfb205837decbd1b3e75f88
---
arch/arm/include/asm/arch-am33xx/cpu.h | 21 +++++++++++++++++++++
board/isee/igep0033/board.c | 6 ++----
board/phytec/pcm051/board.c | 2 --
board/ti/am335x/board.c | 6 +-----
4 Dateien geändert, 24 Zeilen hinzugefügt(+), 11 Zeilen entfernt(-)
diff --git a/arch/arm/include/asm/arch-am33xx/cpu.h
b/arch/arm/include/asm/arch-am33xx/cpu.h
index bcb4c50..945a09b 100644
--- a/arch/arm/include/asm/arch-am33xx/cpu.h
+++ b/arch/arm/include/asm/arch-am33xx/cpu.h
@@ -336,6 +336,27 @@ struct ctrl_dev {
unsigned int resv4[4];
unsigned int miisel; /* offset 0x50 */
};
+
+/* gmii_sel register defines */
+#define GMII1_SEL_MII 0x0
+#define GMII1_SEL_RMII 0x1
+#define GMII1_SEL_RGMII 0x2
+#define GMII1_SEL_NOTUSED 0x3
+#define GMII2_SEL_MII 0x0
+#define GMII2_SEL_RMII 0x4
+#define GMII2_SEL_RGMII 0x8
+#define GMII2_SEL_NOTUSED 0xc
+#define RGMII1_IDMODE BIT(4)
+#define RGMII2_IDMODE BIT(5)
+#define RMII1_IO_CLK_EN BIT(6)
+#define RMII2_IO_CLK_EN BIT(7)
+
+#define MII_MODE_ENABLE (GMII1_SEL_MII | GMII2_SEL_MII)
+#define RMII_MODE_ENABLE (GMII1_SEL_RMII | GMII2_SEL_RMII)
+#define RGMII_MODE_ENABLE (GMII1_SEL_RGMII | GMII2_SEL_RGMII)
+#define RGMII_INT_DELAY (RGMII1_IDMODE | RGMII2_IDMODE)
+#define RMII_CHIPCKL_ENABLE (RMII1_IO_CLK_EN | RMII2_IO_CLK_EN)
+
#endif /* __ASSEMBLY__ */
#endif /* __KERNEL_STRICT_NAMES */
diff --git a/board/isee/igep0033/board.c b/board/isee/igep0033/board.c
index f71aaa0..bdb4745 100644
--- a/board/isee/igep0033/board.c
+++ b/board/isee/igep0033/board.c
@@ -27,9 +27,6 @@
DECLARE_GLOBAL_DATA_PTR;
-/* MII mode defines */
-#define RMII_MODE_ENABLE 0x4D
-
static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
#ifdef CONFIG_SPL_BUILD
@@ -158,7 +155,8 @@ int board_eth_init(bd_t *bis)
eth_setenv_enetaddr("ethaddr", mac_addr);
}
- writel(RMII_MODE_ENABLE, &cdev->miisel);
+ writel((GMII1_SEL_RMII | GMII2_SEL_NOTUSED | RMII1_IO_CLK_EN),
+ &cdev->miisel);
rv = cpsw_register(&cpsw_data);
if (rv < 0)
diff --git a/board/phytec/pcm051/board.c b/board/phytec/pcm051/board.c
index f3bad76..275fe82 100644
--- a/board/phytec/pcm051/board.c
+++ b/board/phytec/pcm051/board.c
@@ -31,8 +31,6 @@
DECLARE_GLOBAL_DATA_PTR;
/* MII mode defines */
-#define MII_MODE_ENABLE 0x0
-#define RGMII_MODE_ENABLE 0xA
#define RMII_RGMII2_MODE_ENABLE 0x49
static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
diff --git a/board/ti/am335x/board.c b/board/ti/am335x/board.c
index eac9cc9..b2bec34 100644
--- a/board/ti/am335x/board.c
+++ b/board/ti/am335x/board.c
@@ -30,10 +30,6 @@
DECLARE_GLOBAL_DATA_PTR;
-/* MII mode defines */
-#define MII_MODE_ENABLE 0x0
-#define RGMII_MODE_ENABLE 0x3A
-
/* GPIO that controls power to DDR on EVM-SK */
#define GPIO_DDR_VTT_EN 7
@@ -460,7 +456,7 @@ int board_eth_init(bd_t *bis)
cpsw_slaves[0].phy_if = cpsw_slaves[1].phy_if =
PHY_INTERFACE_MODE_MII;
} else {
- writel(RGMII_MODE_ENABLE, &cdev->miisel);
+ writel((RGMII_MODE_ENABLE | RGMII_INT_DELAY), &cdev->miisel);
cpsw_slaves[0].phy_if = cpsw_slaves[1].phy_if =
PHY_INTERFACE_MODE_RGMII;
}
--
1.7.11.7
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
