Dear Ash Charles, On 09/03/2013 09:34 PM, Ash Charles wrote: > Hi, > > When using 'nandecc hw' on an OMAP3 platform, data is not being > correctly written to NAND. I see the issue on 2013.10-rc2 and 2013.07 > but not on 2012.10. Specifically, when I read back a SPL binary > written with hardware Hamming ECC, I don't get a matching CRC. With > the BCH8 ECC algorithm, the CRC is correct (but SPL must be written > with Hamming otherwise the board doesn't boot) > > I've shown my steps here: http://pastebin.com/tLZsr9zH > The expected CRC is 46745188. > > Any suggestions/ideas much appreciated!
I'd swear this worked when I changed the command to use BCH ... I'll check it again today. Best regards Andreas Bießmann _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
