qe_init() does not use data copied from NAND. Thise code is not tested or complied causing compilation error during NAND boot
So, remove QE firmware copy from NAND to ddr. Signed-off-by: Prabhakar Kushwaha <[email protected]> --- arch/powerpc/cpu/mpc85xx/cpu_init.c | 13 ------------- 1 file changed, 13 deletions(-) diff --git a/arch/powerpc/cpu/mpc85xx/cpu_init.c b/arch/powerpc/cpu/mpc85xx/cpu_init.c index ea41ffc..36ef232 100644 --- a/arch/powerpc/cpu/mpc85xx/cpu_init.c +++ b/arch/powerpc/cpu/mpc85xx/cpu_init.c @@ -925,19 +925,6 @@ void cpu_secondary_init_r(void) #endif #ifdef CONFIG_QE -#ifdef CONFIG_SYS_QE_FMAN_FW_IN_NAND - int ret; - size_t fw_length = CONFIG_SYS_QE_FMAN_FW_LENGTH; - - /* load QE firmware from NAND flash to DDR first */ - ret = nand_read(&nand_info[0], (loff_t)CONFIG_SYS_QE_FMAN_FW_IN_NAND, - &fw_length, (u_char *)CONFIG_SYS_QE_FW_ADDR); - - if (ret && ret == -EUCLEAN) { - printf ("NAND read for QE firmware at offset %x failed %d\n", - CONFIG_SYS_QE_FMAN_FW_IN_NAND, ret); - } -#endif qe_init(qe_base); qe_reset(); #endif -- 1.7.9.5 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
