Hello, Albert, > On Fri, 17 Oct 2014 16:00:30 +0800, Alison Wang <[email protected]> > wrote: > > To support interactive DDR debugger, cli_simple.o, cli.o, > > cli_readline.o, command.o, s_record.o, xyzModem.o and cmd_disk.o are > > all needed for drivers/ddr/fsl/interactive.c. > > > > In current common/Makefile, the above .o files are only produced when > > CONFIG_SPL_BUILD is disabled. > > > > For LS102xA, interactive DDR debugger is needed in SD/NAND boot too, > > and I enabled CONFIG_FSL_DDR_INTERACTIVE. But according to the > current > > common/Makfile, all the above .o files are not produced in SPL part > > because CONFIG_SPL_BUILD is enabled in SPL part, the following error > > will be shown, > > > > drivers/ddr/fsl/built-in.o: In function `fsl_ddr_interactive': > > /home/wangh/layerscape/u-boot/drivers/ddr/fsl/interactive.c:1871: > > undefined reference to `cli_readline_into_buffer' > > /home/wangh/layerscape/u-boot/drivers/ddr/fsl/interactive.c:1873: > > undefined reference to `cli_simple_parse_line' > > make[1]: *** [spl/u-boot-spl] Error 1 > > make: *** [spl/u-boot-spl] Error 2 > > > > So this patch fixed this issue and the above .o files will be > produced > > no matter CONFIG_SPL_BUILD is enabled or disabled. > > > > Signed-off-by: Alison Wang <[email protected]> > > --- > > Change log: > > v3: Gave more explaination in the commit. > > v2: No change. > > This does not apply cleanly. Could you rebase and resubmit? [Alison Wang] ok, I will rebase and resubmit the set. Thanks.
Best Regards, Alison Wang _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
