On Thursday, October 30, 2014 at 12:22:57 PM, Pavel Machek wrote: > On Thu 2014-10-30 10:30:25, Marek Vasut wrote: > > Add example config file entry for the Altera SPI controller. This SPI > > controller can also, under special conditions, be used to operate the > > EPCS/EPCQ SPI NOR. > > > > Signed-off-by: Marek Vasut <ma...@denx.de> > > Cc: Chin Liang See <cl...@altera.com> > > Cc: Dinh Nguyen <dingu...@opensource.altera.com> > > Cc: Vince Bridgers <vbrid...@altera.com> > > Acked-by: Pavel Machek <pa...@denx.de> > > > --- a/include/configs/socfpga_common.h > > +++ b/include/configs/socfpga_common.h > > @@ -79,6 +79,25 @@ > > > > #define CONFIG_SYS_PL310_BASE SOCFPGA_MPUL2_ADDRESS > > > > /* > > > > + * EPCS/EPCQx1 Serial Flash Controller > > + */ > > +#ifdef CONFIG_ALTERA_SPI > > +#define CONFIG_CMD_SPI > > +#define CONFIG_CMD_SF > > +#define CONFIG_SF_DEFAULT_SPEED 30000000 > > +#define CONFIG_SPI_FLASH > > +#define CONFIG_SPI_FLASH_STMICRO > > +#define CONFIG_SPI_FLASH_BAR > > +/* > > + * The base address is configurable in QSys, each board must specify the > > + * base address based on it's particular FPGA configuration. Please note > > + * that the address here is incremented by 0x400 from the Base address > > Are the double spaces around 0x400 intentional?
Yes, to stress it out and align the text to a nice block ;-) Best regards, Marek Vasut _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
