On 4 March 2015 at 00:46, Simon Glass <[email protected]> wrote: > Hi Michal, > > On 2 March 2015 at 04:25, Michal Suchanek <[email protected]> wrote: >> Hello, >> >> On 18 February 2015 at 06:24, Michal Suchanek <[email protected]> wrote: >>> On 18 February 2015 at 03:27, Simon Glass <[email protected]> wrote: >>>> Hi Michal, >>>> >>>> On 16 February 2015 at 04:41, Michal Suchanek <[email protected]> wrote: >>>>> On 13 February 2015 at 05:51, Simon Glass <[email protected]> wrote: >>>>>> Hi Michal, >>>>>> >>>>>> On 11 February 2015 at 10:16, Michal Suchanek <[email protected]> wrote: >>>>>>> >>>>>>> Hello, >>>>>>> >>>>>>> I changed the SYS_START to work around the bug in the manufacturer >>>>>>> firmware, applied snow_defconfig, built u-boot.bin, packed it into >>>>>>> kernel uimage, signed it, copied it to a kernel partition, bumped >>>>>>> priority of the partition, and rebooted. >>>>>>> >>>>>> >>>>>> Do you mean u-boot-dtb.bin? If not you won't get a device tree and it >>>>>> won't work. >>>>> >>>>> No, u-boot.bin. With u-boot-dtb.bin I get a snow # prompt on the >>>>> built-in LCD, and working keyboard. >>>> >>>> OK sounds like it is working, good! I wonder if we should have a page >>>> on elinux.org? >> >> It is working to some extent. >> >> I managed to load kernel from the emmc which works fine but the kernel >> cannot read the emmc after it boots because it does not properly parse >> the partitioning scheme. This should be trivially fixable in the >> kernel and might actually work if I updated my sources but rebasing >> the extra patches required for Snow is not automatically handled. >> >> On the other hand, the linux kernel has no problem with the SDXC card >> in the SD slot and can read it just fine. Unfortunately, u-boot >> complains about EFI partition errors and won't load anything from the >> card. I tried two different GPT partitioning tools on the card and >> both say that the partition layout is fine and that I have the default >> 128 entries. >> >> How can I tell why u-boot does not like my GPT label? > > You could debug it in U-Boot and see what is going wrong.
Presumably. How do I do that? The available external partitioning tools say the GPT label is OK. u-boot has afaik no partitioning tools built-in so all I get is something along the lines "I don't like this partition layout, go away". Without serial console I don't have the exact messages captured but they did not say anything about reason why u-boot did not like the label. Presumably I can insert some debug prints in the ext2 commands. Maybe they should have been there to start with so that users who cannot load a file get some diagnostic why loading the file failed? Thanks Michal _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
