Hello Simon,

On 03/28/2015 04:08 PM, Simon Glass wrote:
Hi Przemyslaw,

On 27 March 2015 at 11:33, Przemyslaw Marczak <[email protected]> wrote:
Signed-off-by: Przemyslaw Marczak <[email protected]>
Cc: Masahiro Yamada <[email protected]>
Cc: Mike Frysinger <[email protected]>
Cc: Simon Glass <[email protected]>
Cc: Heiko Schocher <[email protected]>

Changes V2:
- add i2c uclass description
---
  drivers/i2c/Kconfig | 17 +++++++----------
  1 file changed, 7 insertions(+), 10 deletions(-)

Acked-by: Simon Glass <[email protected]>

(see nit below)


diff --git a/drivers/i2c/Kconfig b/drivers/i2c/Kconfig
index 692810d..979522f 100644
--- a/drivers/i2c/Kconfig
+++ b/drivers/i2c/Kconfig
@@ -2,16 +2,13 @@ config DM_I2C
         bool "Enable Driver Model for I2C drivers"
         depends on DM
         help
-         Enable driver model for I2C. This SPI flash interface
-         (spi_flash_probe(), spi_flash_write(), etc.) is then
-         implemented by the SPI flash uclass. There is one standard
-         SPI flash driver which knows how to probe most chips
-         supported by U-Boot. The uclass interface is defined in
-         include/spi_flash.h, but is currently fully compatible
-         with the old interface to avoid confusion and duplication
-         during the transition parent. SPI and SPI flash must be
-         enabled together (it is not possible to use driver model
-         for one and not the other).
+         Enable driver model for I2C. The I2C uclass interface: probe, read,
+         write or speed, is implemented with the bus drivers uclass operations,
+         which provides methods for bus setting and data transfer. Each chip

Can we tweak this a bit?

          write and speed, is implemented with the bus drivers' operations,
          which provide methods for bus setting and data transfer. Each chip



Ok, will corrent this.

+         device (bus child) info is kept as parent platdata. The interface is
+         defined in include/i2c.h. When i2c bus driver supports the i2c uclass,
+         but the device drivers not, then DM_I2C_COMPAT config can be used as
+         compatibility layer.

  config DM_I2C_COMPAT
         bool "Enable I2C compatibility layer"
--
1.9.1


Regards,
Simon


Best regards,
--
Przemyslaw Marczak
Samsung R&D Institute Poland
Samsung Electronics
[email protected]
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to