Hi Stephen,

>>              Finally, the example scripts support two boards; my
>>         home/laptop dev
>>              setup that uses a Numato relay board to control the signals
>>         to the
>>              board I use there, and my work desktop dev setup that
>> uses our
>>              "PM342" debug board to controll the signals. The latter
>> works
>>              logically the same as the numato relay board, except it
>>         contains
>>              electronic switches driven by an FTDI chip.
>>
>>         I expect this is FTDI chip on the target right?
>>
>>
>>     It's actually a separate common debug board. Most/all of our
>>     development boards (and perhaps some production boards) have a
>>     standardized connector into which the common debug board plugs.
>>
>>
>>
>> ok.
>> I think my setup is not that far from what you are using and I expect
>> that others SoCs will be very similar.
>> Do you have any other testcases which you are running and you haven't
>> sent?
> 
> Not at present.
> 
> As an FYI, I typically publish my local work-in-progress branch at:
> git://github.com/swarren/u-boot.git tegra_dev

I have looked at your patches and no problem to get it work on
microblaze and zynq board. I do use kermit without any problem.
I used cu on Microblaze.

- What I do miss is power off functionality because it is not practical
to keep board always on. On can be solved via reset script.

- Then place tests to separate folder for better separation.

- I see that output log doesn't handle tabs correctly - output from i2c
bus for example.

- Is there any way to handle timeouts or stucks? For example to
recognize if sleep 60 fails or just takes long. It means setting up
timeouts will be good.

I will have more comments when I spend more time with it but it looks
pretty good for start.

Thanks,
Michal


-- 
Michal Simek, Ing. (M.Eng), OpenPGP -> KeyID: FE3D1F91
w: www.monstr.eu p: +42-0-721842854
Maintainer of Linux kernel - Microblaze cpu - http://www.monstr.eu/fdt/
Maintainer of Linux kernel - Xilinx Zynq ARM architecture
Microblaze U-BOOT custodian and responsible for u-boot arm zynq platform


Attachment: signature.asc
Description: OpenPGP digital signature

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to