[U-Boot] [PATCH] net: phy: ti: Enable automatic crossover mode

[Michal Simek]

Enable automatic crossover cable detection.

Signed-off-by: Michal Simek <michal.si...@xilinx.com>
---

 drivers/net/phy/ti.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/net/phy/ti.c b/drivers/net/phy/ti.c
index 541a57f98028..c3912d52f320 100644
--- a/drivers/net/phy/ti.c
+++ b/drivers/net/phy/ti.c
@@ -41,6 +41,8 @@
 
 /* PHY CTRL bits */
 #define DP83867_PHYCR_FIFO_DEPTH_SHIFT         14
+#define DP83867_MDI_CROSSOVER          5
+#define DP83867_MDI_CROSSOVER_AUTO     2
 
 /* RGMIIDCTL bits */
 #define DP83867_RGMII_TX_CLK_DELAY_SHIFT       4
@@ -149,6 +151,7 @@ static int dp83867_config(struct phy_device *phydev)
 
        if (phy_interface_is_rgmii(phydev)) {
                ret = phy_write(phydev, MDIO_DEVAD_NONE, MII_DP83867_PHYCTRL,
+                       (DP83867_MDI_CROSSOVER_AUTO << DP83867_MDI_CROSSOVER) |
                        (FIFO_DEPTH << DP83867_PHYCR_FIFO_DEPTH_SHIFT));
                if (ret)
                        return ret;
-- 
1.9.1

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot