On Tue, Aug 2, 2016 at 3:55 AM, Stefan Agner <ste...@agner.ch> wrote: > From: Stefan Agner <stefan.ag...@toradex.com> > > Currently the command buffer gets allocated with a size of 32 bytes. > This causes warning messages on systems with cache lines bigger than > 32 bytes: > CACHE: Misaligned operation at range [9df17a00, 9df17a20] > > Define command buffer to be at least 32 bytes, but more if cache > line is bigger. > > Signed-off-by: Stefan Agner <stefan.ag...@toradex.com> > --- > This appeared after Simon enable the message in check_cache_range > by default...
On mx6ul pico I also get similar warnings even though NAND is not used on this board: U-Boot 2016.09-rc1-00245-gad6a303 (Aug 03 2016 - 10:31:52 -0300) CPU: Freescale i.MX6UL rev1.0 at 396 MHz Reset cause: WDOG Board: PICO-IMX6UL-EMMC I2C: ready DRAM: 256 MiB CACHE: Misaligned operation at range [8fff0000, 8fff0004] CACHE: Misaligned operation at range [8fff0024, 8fff0028] PMIC: PFUZE3000 DEV_ID=0x30 REV_ID=0x11 MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: FEC Hit any key to stop autoboot: 0 Looks like we need a more generic fix? Thanks _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot