On Tue, Aug 23, 2016 at 08:05:59PM +0200, Marcus Glocker wrote: > On Mon, Aug 22, 2016 at 09:55:01AM +0200, Boris Brezillon wrote: > > > +Glaucio who is facing the same problem but on a cubieboard2. > > > > On Sun, 21 Aug 2016 16:14:39 +0200 > > Boris Brezillon <[email protected]> wrote: > > > > > Hi, > > > > > > On Sun, 21 Aug 2016 12:03:19 +0200 > > > Hans de Goede <[email protected]> wrote: > > > > > > > Hi, > > > > > > > > On 21-08-16 11:01, Marcus Glocker wrote: > > > > > On Sat, Aug 20, 2016 at 03:05:38PM -0400, Tom Rini wrote: > > > > > > > > > >> On Sat, Aug 20, 2016 at 07:26:19AM +0200, Marcus Glocker wrote: > > > > >>> Hello, > > > > >>> > > > > >>> While U-Boot SPL 2015.10 works fine on my allwinner,sun5i-r8 board I > > > > >>> face following issue with U-Boot SPL 2016.09-rc1 on it: > > > > >>> > > > > >>> bash-4.3# cu -l /dev/cuaU0 -s 115200 > > > > >>> Connected to /dev/cuaU0 (speed 115200) > > > > >>> > > > > >>> U-Boot SPL 2016.09-rc1 (Jul 31 2016 - 16:37:00) > > > > >>> DRAM: 512 MiB > > > > >>> CPU: 1008000000Hz, AXI/AHB/APB: 3/2/2 > > > > >>> Trying to boot from NAND > > > > >>> ### ERROR ### Please RESET the board ### > > > > >>> > > > > >>> Any ideas what change did cause this or where to start looking > > > > >>> after? > > > > > > Markus, can you share your .config? > > > I tested the different bits while submitting the NAND driver and the > > > SPL NAND driver improvements and it was working fine. > > > I'll try to test 2016.09-rc1 tomorrow. > > > > Just tried to boot a mainline uboot on my CHIP and it boots fine [1]. > > Here is my .config [2], can you compare yours with this one? > > > > Can you also detail how you flash the images? > > Thanks for sharing your configuration! Based on that I was able to > narrow down the configuration parameter which makes SPL 2016.09-rc1 now > work on my allwinner,sun5i-r8 board as well: > > +CONFIG_USE_PRIVATE_LIBGCC=n > > When I don't set it explicitly I get 'CONFIG_USE_PRIVATE_LIBGCC=y' in > my .config. Could it be that it was set to 'n' by default in previous > releases?
What toolchain exactly are you using? Thanks! -- Tom
signature.asc
Description: Digital signature
_______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
