On Sen, 2016-10-17 at 17:20 +0200, Marek Vasut wrote: > On 10/17/2016 05:14 PM, Chin Liang See wrote: > > > > On Sen, 2016-10-17 at 15:42 +0200, Marek Vasut wrote: > > > > > > On 10/17/2016 03:35 PM, See, Chin Liang wrote: > > > > > > > > > > > > On Min, 2016-10-16 at 17:34 +0200, Marek Vasut wrote: > > > > > > > > > > > > > > > On 10/13/2016 10:33 AM, Chin Liang See wrote: > > > > > > > > > > > > > > > > > > > > > > > > Disable the FPGA Manager for Stratix 10 SoC as we are not > > > > > > using this for SOCVP > > > > > If it's not used on SoCVP, then shouldn't this be disabled > > > > > only > > > > > for > > > > > SoCVP instead of S10 ? > > > > > > > > > We will be enhancing this code to support the hardware / > > > > emulation > > > > in > > > > later phase. In another word, will switch the support from > > > > SOCVP to > > > > hardware once its available. > > > > > > > This is confusing, what would happen if someone tries to use old > > > u- > > > boot > > > on real hardware ? > > It won't work until added drivers for Clocks, Reset and DDR. > > Current > > state would be good for SOCVP only where not all hardware is > > simulated. > In that case, mark it as SoCVP to prevent confusion please. >
In this case, I can update the config to indicate this is S10 SOCVP. Thanks Chin Liang > > -- > Best regards, > Marek Vasut > > ________________________________ > > Confidentiality Notice. > This message may contain information that is confidential or > otherwise protected from disclosure. If you are not the intended > recipient, you are hereby notified that any use, disclosure, > dissemination, distribution, or copying of this message, or any > attachments, is strictly prohibited. If you have received this > message in error, please advise the sender by reply e-mail, and > delete the message and any attachments. Thank you. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot