On Min, 2016-10-16 at 17:34 +0200, Marek Vasut wrote: > On 10/13/2016 10:33 AM, Chin Liang See wrote: > > > > Disable the FPGA Manager for Stratix 10 SoC as we are not > > using this for SOCVP > If it's not used on SoCVP, then shouldn't this be disabled only for > SoCVP instead of S10 ? >
We will be enhancing this code to support the hardware / emulation in later phase. In another word, will switch the support from SOCVP to hardware once its available. Thanks Chin Liang > > > > Signed-off-by: Chin Liang See <cl...@altera.com> > > Cc: Marek Vasut <ma...@denx.de> > > Cc: Dinh Nguyen <dingu...@opensource.altera.com> > > Cc: Ley Foon Tan <lf...@altera.com> > > Cc: Tien Fong Chee <tfc...@altera.com> > > --- > > arch/arm/mach-socfpga/Makefile | 5 +++-- > > 1 file changed, 3 insertions(+), 2 deletions(-) > > > > diff --git a/arch/arm/mach-socfpga/Makefile b/arch/arm/mach- > > socfpga/Makefile > > index 809cd47..a8ea277 100644 > > --- a/arch/arm/mach-socfpga/Makefile > > +++ b/arch/arm/mach-socfpga/Makefile > > @@ -8,12 +8,13 @@ > > # > > > > obj-y += misc.o timer.o reset_manager.o system_manager.o > > clock_manager.o \ > > - fpga_manager.o board.o > > + board.o > > > > obj-$(CONFIG_SPL_BUILD) += spl.o freeze_controller.o > > > > # QTS-generated config file wrappers > > -obj-$(CONFIG_TARGET_SOCFPGA_GEN5) += scan_manager.o > > wrap_pll_config.o > > +obj-$(CONFIG_TARGET_SOCFPGA_GEN5) += scan_manager.o > > wrap_pll_config.o \ > > + fpga_manager.o > > obj-$(CONFIG_SPL_BUILD) += wrap_iocsr_config.o > > wrap_pinmux_config.o \ > > wrap_sdram_config.o > > CFLAGS_wrap_iocsr_config.o += -I$(srctree)/board/$(BOARDDIR) > > > > -- > Best regards, > Marek Vasut > > ________________________________ > > Confidentiality Notice. > This message may contain information that is confidential or > otherwise protected from disclosure. If you are not the intended > recipient, you are hereby notified that any use, disclosure, > dissemination, distribution, or copying of this message, or any > attachments, is strictly prohibited. If you have received this > message in error, please advise the sender by reply e-mail, and > delete the message and any attachments. Thank you. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot