Low Frequency Periodic Signaling (LFPS) Peak-to-Peak Differential Output Voltage Test Compliance fails using default transmitter settings
Change settings required for transmitter signal swings to pass compliance tests. Signed-off-by: Sriram Dash <[email protected]> Signed-off-by: Rajesh Bhagat <[email protected]> Signed-off-by: Suresh Gupta <[email protected]> --- Changes in v2: None Changes in V3: Change CONFIG_XXX to CONFIG_ARCH_XXX arch/arm/cpu/armv8/fsl-layerscape/Kconfig | 6 +++++ arch/arm/cpu/armv8/fsl-layerscape/soc.c | 29 ++++++++++++++++++++++ .../include/asm/arch-fsl-layerscape/immap_lsch2.h | 4 +++ .../include/asm/arch-fsl-layerscape/immap_lsch3.h | 2 ++ 4 files changed, 41 insertions(+) diff --git a/arch/arm/cpu/armv8/fsl-layerscape/Kconfig b/arch/arm/cpu/armv8/fsl-layerscape/Kconfig index 28a0015..d5d6040 100644 --- a/arch/arm/cpu/armv8/fsl-layerscape/Kconfig +++ b/arch/arm/cpu/armv8/fsl-layerscape/Kconfig @@ -24,6 +24,7 @@ config ARCH_LS1043A select SYS_FSL_ERRATUM_A010539 select SYS_FSL_ERRATUM_A009008 select SYS_FSL_ERRATUM_A009798 + select SYS_FSL_ERRATUM_A008997 select SYS_FSL_HAS_DDR3 select SYS_FSL_HAS_DDR4 select ARCH_EARLY_INIT_R @@ -44,6 +45,7 @@ config ARCH_LS1046A select SYS_FSL_ERRATUM_A010539 select SYS_FSL_ERRATUM_A009008 select SYS_FSL_ERRATUM_A009798 + select SYS_FSL_ERRATUM_A008997 select SYS_FSL_HAS_DDR4 select SYS_FSL_SRDS_2 select ARCH_EARLY_INIT_R @@ -74,6 +76,7 @@ config ARCH_LS2080A select SYS_FSL_ERRATUM_A010165 select SYS_FSL_ERRATUM_A009008 select SYS_FSL_ERRATUM_A009798 + select SYS_FSL_ERRATUM_A008997 select ARCH_EARLY_INIT_R select BOARD_EARLY_INIT_F @@ -161,6 +164,9 @@ config SYS_FSL_ERRATUM_A009008 config SYS_FSL_ERRATUM_A009798 bool "Workaround for USB PHY erratum A009798" +config SYS_FSL_ERRATUM_A008997 + bool "Workaround for USB PHY erratum A008997" + config MAX_CPUS int "Maximum number of CPUs permitted for Layerscape" default 4 if ARCH_LS1043A diff --git a/arch/arm/cpu/armv8/fsl-layerscape/soc.c b/arch/arm/cpu/armv8/fsl-layerscape/soc.c index 8d86985..c56cb72 100644 --- a/arch/arm/cpu/armv8/fsl-layerscape/soc.c +++ b/arch/arm/cpu/armv8/fsl-layerscape/soc.c @@ -94,6 +94,33 @@ static void erratum_a009798(void) #endif /* CONFIG_SYS_FSL_ERRATUM_A009798 */ } +static void erratum_a008997(void) +{ +#ifdef CONFIG_SYS_FSL_ERRATUM_A008997 +#if defined(CONFIG__ARCH_LS1043A) || defined(CONFIG_ARCH_LS1046A) + u32 __iomem *scfg = (u32 __iomem *)SCFG_BASE; + u32 val = scfg_in32(scfg + SCFG_USB3PRM2CR_USB1 / 4); + val &= ~(0x7F << 9); + scfg_out32(scfg + SCFG_USB3PRM2CR_USB1 / 4, + val | (USB_PCSTXSWINGFULL << 9)); + val = scfg_in32(scfg + SCFG_USB3PRM2CR_USB2 / 4); + val &= ~(0x7F << 9); + scfg_out32(scfg + SCFG_USB3PRM2CR_USB2 / 4, + val | (USB_PCSTXSWINGFULL << 9)); + val = scfg_in32(scfg + SCFG_USB3PRM2CR_USB3 / 4); + val &= ~(0x7F << 9); + scfg_out32(scfg + SCFG_USB3PRM2CR_USB3 / 4, + val | (USB_PCSTXSWINGFULL << 9)); +#elif defined(CONFIG_ARCH_LS2080A) || defined(CONFIG_ARCH_LS2085A) + u32 __iomem *scfg = (u32 __iomem *)SCFG_BASE; + u32 val = scfg_in32(scfg + SCFG_USB3PRM2CR / 4); + val &= ~(0x7F << 9); + scfg_out32(scfg + SCFG_USB3PRM2CR / 4, + val | (USB_PCSTXSWINGFULL << 9)); +#endif +#endif /* CONFIG_SYS_FSL_ERRATUM_A008997 */ +} + #if defined(CONFIG_FSL_LSCH3) /* * This erratum requires setting a value to eddrtqcr1 to @@ -238,6 +265,7 @@ void fsl_lsch3_early_init_f(void) erratum_a008336(); erratum_a009008(); erratum_a009798(); + erratum_a008997(); #ifdef CONFIG_CHAIN_OF_TRUST /* In case of Secure Boot, the IBR configures the SMMU * to allow only Secure transactions. @@ -507,6 +535,7 @@ void fsl_lsch2_early_init_f(void) erratum_a010539(); erratum_a009008(); erratum_a009798(); + erratum_a008997(); } #endif diff --git a/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch2.h b/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch2.h index 8bd40e8..2e52078 100644 --- a/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch2.h +++ b/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch2.h @@ -339,10 +339,14 @@ struct ccsr_gur { #define SCFG_BASE 0x01570000 #define SCFG_USB3PRM1CR_USB1 0x070 +#define SCFG_USB3PRM2CR_USB1 0x074 #define SCFG_USB3PRM1CR_USB2 0x07C +#define SCFG_USB3PRM2CR_USB2 0x080 #define SCFG_USB3PRM1CR_USB3 0x088 +#define SCFG_USB3PRM2CR_USB3 0x08c #define USB_TXVREFTUNE 0x9 #define USB_SQRXTUNE 0xFC7FFFFF +#define USB_PCSTXSWINGFULL 0x47 #define SCFG_SNPCNFGCR_SECRDSNP 0x80000000 #define SCFG_SNPCNFGCR_SECWRSNP 0x40000000 diff --git a/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch3.h b/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch3.h index 3537ecb..3106ed3 100644 --- a/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch3.h +++ b/arch/arm/include/asm/arch-fsl-layerscape/immap_lsch3.h @@ -128,9 +128,11 @@ /* Supplemental Configuration */ #define SCFG_BASE 0x01fc0000 #define SCFG_USB3PRM1CR 0x000 +#define SCFG_USB3PRM2CR 0x004 #define SCFG_USB3PRM1CR_INIT 0x27672b2a #define USB_TXVREFTUNE 0x9 #define USB_SQRXTUNE 0xFC7FFFFF +#define USB_PCSTXSWINGFULL 0x47 #define SCFG_QSPICLKCTLR 0x10 #define TP_ITYP_AV 0x00000001 /* Initiator available */ -- 1.9.3 _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
