Hi Jaehoon, On 22 July 2017 at 11:15, Simon Glass <[email protected]> wrote: > (pruning the cc list a bit) > > Hi Jaehoon, > > On 4 July 2017 at 13:48, Simon Glass <[email protected]> wrote: >> This series completes the conversion of SATA to driver model. >> >> Previous work converted SCSI including the SCSI-based SATA driver. This >> series converts the AHCI uclass itself, adding operations and adjusting >> the 'sata' command to work correctly. >> >> An existing board (Compulab Utilite) is used for this work. It uses SATA >> without the SCSI layer. Unfortunately this board does not currently use >> driver model for MMC or USB, nor does it include a device tree. Therefore >> additional patches are included in this series to convert this over. Note >> that USB is rendered inoperative since the relevant device-tree nodes are >> disabled. Further work is needed here (e.g. by the board maintainer) but >> it is well beyond the objective of this series. >> >> A long-standing niggle with MMC has been the CONFIG_DM_MMC_OPS option. >> This was introduced to allow driver model to handle MMC operations rather >> than having them in struct mmc. This was needed since the original uclass >> did not have support for operations. >> >> At present i.MX is the only SoC that defines CONFIG_DM_MMC without >> CONFIG_DM_MMC_OPS. With this driver converted, the option is no longer >> necessary so this series takes the opportunity to drop that option. > > Are you planning to review / apply this series please? It is assigned > to you in patchwork. I'd like to resolve this because I have two other > series depending on it
Actually there is another previous series also. Together they finish the conversion of SATA/SCSI to driver model. The dependent series are the final command Kconfig conversion and the environment series, although the later could probably be rebased without too much pain. Regards, Simon _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
