From: Joe Hershberger <[email protected]> Zynq NAND driver is not support for NAND lock or unlock operation. Hence, accidentally write into the critical NAND region might cause data corruption to occur.
This commit is to add NAND lock/unlock command into NAND SMC register set for NAND lock/unlock operaion. Signed-off-by: Joe Hershberger <[email protected]> Signed-off-by: Keng Soon Cheah <[email protected]> Cc: Chen Yee Chew <[email protected]> Cc: Siva Durga Prasad Paladugu <[email protected]> Cc: Michal Simek <[email protected]> Cc: Scott Wood <[email protected]> Signed-off-by: Wilson Lee <[email protected]> --- drivers/mtd/nand/zynq_nand.c | 12 ++++++++++++ 1 file changed, 12 insertions(+) diff --git a/drivers/mtd/nand/zynq_nand.c b/drivers/mtd/nand/zynq_nand.c index 948f059..484f1bb 100644 --- a/drivers/mtd/nand/zynq_nand.c +++ b/drivers/mtd/nand/zynq_nand.c @@ -81,6 +81,13 @@ #define ZYNQ_NAND_ECC_BUSY (1 << 6) /* ECC block is busy */ #define ZYNQ_NAND_ECC_MASK 0x00FFFFFF /* ECC value mask */ +#ifndef NAND_CMD_LOCK_TIGHT +#define NAND_CMD_LOCK_TIGHT 0x2c +#endif + +#ifndef NAND_CMD_LOCK_STATUS +#define NAND_CMD_LOCK_STATUS 0x7a +#endif /* SMC register set */ struct zynq_nand_smc_regs { @@ -141,6 +148,11 @@ static const struct zynq_nand_command_format zynq_nand_commands[] = { {NAND_CMD_PARAM, NAND_CMD_NONE, 1, 0}, {NAND_CMD_GET_FEATURES, NAND_CMD_NONE, 1, 0}, {NAND_CMD_SET_FEATURES, NAND_CMD_NONE, 1, 0}, + {NAND_CMD_LOCK, NAND_CMD_NONE, 0, 0}, + {NAND_CMD_LOCK_TIGHT, NAND_CMD_NONE, 0, 0}, + {NAND_CMD_UNLOCK1, NAND_CMD_NONE, 3, 0}, + {NAND_CMD_UNLOCK2, NAND_CMD_NONE, 3, 0}, + {NAND_CMD_LOCK_STATUS, NAND_CMD_NONE, 3, 0}, {NAND_CMD_NONE, NAND_CMD_NONE, 0, 0}, /* Add all the flash commands supported by the flash device */ }; -- 2.7.4 _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
