Dear Dave Mitchell, In message <[email protected]> you wrote: > Current de-assert reset is not sufficient for the USB PHY reset > on some Canyonlands platforms. The patch adds an assert/de-assert > sequence. This addresses a USB detection problem for devices > attached prior to power-up. The delay lengths are needed for > power to the PHY to stabilize. > > Signed-off-by: Jeff Mann <[email protected]> > Signed-off-by: Dave Mitchell <[email protected]> > Acked-by: Tirumala Reddy Marri <[email protected]> > --- > v1->v2: fixed typo
NAK again. This does not belong in generic board init code. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: [email protected] Documentation is the castor oil of programming. Managers know it must be good because the programmers hate it so much. _______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
