Hi Stefan, I am using PPC440GX. I did not understood what mean by EEPROM configuration. Do you want to say that board is using data from EEPROM? I believe I am using fix configuration as I am not calling any I2C call in bootloader code.
How to check this hard reset issue. Thanks in Advance. Prakash On Wed, Dec 30, 2009 at 10:51 AM, Stefan Roese <[email protected]> wrote: > On Tuesday 29 December 2009 16:04:28 prakash bedge wrote: > > I am facing an error while flashing u-boot on my PPC4xx based board. > > What kind of PPC4xx are you using (405EX, 440SP, 440EPx, 460EX...)? > > > When I flash the u-boot on the PCI board I am developing, and hard reset > > the board, then the board is not able to boot up. > > Also I am not able to debug the code as probe connection fails. > > > > Whar are the reason that I should check to see why the board is not > booting > > up after hard reset. > > Is it fault in start.S or somewhere else in code I need to see? > > > > It would be great if someone who already have a solution on this > > porblem, share his experience. > > I suspect some problems with the bootstrap configuration. Are you using a > fixed bootstrap option? Or are you using the bootstrap I2C EEPROM? If yes, > is > this EEPROM configured correctly? > > Cheers, > Stefan > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: (+49)-8142-66989-0 Fax: (+49)-8142-66989-80 Email: [email protected] >
_______________________________________________ U-Boot mailing list [email protected] http://lists.denx.de/mailman/listinfo/u-boot
