On Thu, Feb 22, 2018 at 7:20 AM, Andre Przywara <andre.przyw...@arm.com> wrote: > As we are running into issues where the final U-Boot FIT image file is > exceeding our size limit, add a hint to the README.sunxi64 file > to point out the possibility of building non-debug versions of the ATF > binary. This is about 12KB smaller than the standard debug build, and > so again allows successful U-Boot builds for many boards with the > Allwinner H5 SoC. > Please note that under normal circumstances the debug build is still > recommended, as it gives valuable clues in case something goes wrong in > the ATF.
So for H5 we can't able to use debug (: > > Signed-off-by: Andre Przywara <andre.przyw...@arm.com> > --- > Hi, > > as the level of desperation about Allwinner 64-bit FIT image sizes rises, > we are getting more into the slightly cheaty section with our mitigations. > However as my previous attempts in fixing this issue were not that warmly > welcomed, I now suggest this rather pragmatic solution, which avoids hacking > U-Boot badly. This fixes the various H5 builds for me. > > Cheers, > Andre. > > board/sunxi/README.sunxi64 | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/board/sunxi/README.sunxi64 b/board/sunxi/README.sunxi64 > index c492f749b8..eefa5001a2 100644 > --- a/board/sunxi/README.sunxi64 > +++ b/board/sunxi/README.sunxi64 > @@ -38,6 +38,12 @@ the root of your U-Boot build directory (or create a > symbolic link). > $ export BL31=/src/arm-trusted-firmware/build/sun50iw1p1/debug/bl31.bin > (adjust the actual path accordingly) > > +If you run into size issues with the resulting U-Boot image file, it might > +help to use a release build, by using "DEBUG=0" when building bl31.bin. This is something like release build even w/o DEBUG=0 it will build same is it? In that case we can say not to use DEBUG=1 just make PLAT=sun50iw1p1 bl31 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot