Spam detection software, running on the system "lists.denx.de",
has identified this incoming email as possible spam.  The original
message has been attached to this so you can view it or label
similar future email.  If you have any questions, see
@@CONTACT_ADDRESS@@ for details.

Content preview:  I2C bus 1 is used for the accelerometer and i2c bus 2 for
  the touchscreen of the device. While these are not supported in U-Boot, its
   command line can be used to access these peripherals. Signed-off-by: Paul
   Kocialkowski <[email protected]> --- configs/Ainol_AW1_defconfig | 2 ++ 1
  file changed, 2 insertions(+) [...] 

Content analysis details:   (5.2 points, 5.0 required)

 pts rule name              description
---- ---------------------- --------------------------------------------------
 1.3 RCVD_IN_RP_RNBL        RBL: Relay in RNBL,
                            https://senderscore.org/blacklistlookup/
                           [77.128.107.220 listed in bl.score.senderscore.com]
 0.0 RCVD_IN_SORBS_DUL      RBL: SORBS: sent directly from dynamic IP address
                            [77.128.107.220 listed in dnsbl.sorbs.net]
 3.6 RCVD_IN_PBL            RBL: Received via a relay in Spamhaus PBL
                            [77.128.107.220 listed in zen.spamhaus.org]
 0.4 RDNS_DYNAMIC           Delivered to internal network by host with
                            dynamic-looking rDNS


--- Begin Message ---
I2C bus 1 is used for the accelerometer and i2c bus 2 for the
touchscreen of the device. While these are not supported in U-Boot, its
command line can be used to access these peripherals.

Signed-off-by: Paul Kocialkowski <[email protected]>
---
 configs/Ainol_AW1_defconfig | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/configs/Ainol_AW1_defconfig b/configs/Ainol_AW1_defconfig
index 9fb464b703..87f14b0ea5 100644
--- a/configs/Ainol_AW1_defconfig
+++ b/configs/Ainol_AW1_defconfig
@@ -4,6 +4,8 @@ CONFIG_MACH_SUN7I=y
 CONFIG_DRAM_CLK=432
 CONFIG_DRAM_ZQ=123
 CONFIG_MMC0_CD_PIN="PH1"
+CONFIG_I2C1_ENABLE=y
+CONFIG_I2C2_ENABLE=y
 CONFIG_USB0_VBUS_PIN="PB9"
 CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
 CONFIG_USB0_ID_DET="PH4"
-- 
2.16.2


--- End Message ---
_______________________________________________
U-Boot mailing list
[email protected]
https://lists.denx.de/listinfo/u-boot

Reply via email to