+ Siva On Fri, May 25, 2018 at 1:28 AM, Marek Vasut <[email protected]> wrote: > The N25Q256(A) datasheet clearly states that this device does have > a Flag Status Register and does update FSR PEC bit 7 during Program > and Erase cycles to indicate the cycle is in progress. Enable the > FSR PEC bit polling on this device to prevent data corruption. > > Signed-off-by: Marek Vasut <[email protected]> > Cc: Jagan Teki <[email protected]> > Cc: Tom Rini <[email protected]> > --- > drivers/mtd/spi/spi_flash_ids.c | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/mtd/spi/spi_flash_ids.c b/drivers/mtd/spi/spi_flash_ids.c > index 3b8f254ca2..fbc1bb6a5e 100644 > --- a/drivers/mtd/spi/spi_flash_ids.c > +++ b/drivers/mtd/spi/spi_flash_ids.c > @@ -130,8 +130,8 @@ const struct spi_flash_info spi_flash_ids[] = { > {"n25q64a", INFO(0x20bb17, 0x0, 64 * 1024, 128, RD_FULL | > WR_QPP | SECT_4K) }, > {"n25q128", INFO(0x20ba18, 0x0, 64 * 1024, 256, RD_FULL | > WR_QPP) }, > {"n25q128a", INFO(0x20bb18, 0x0, 64 * 1024, 256, RD_FULL | > WR_QPP) }, > - {"n25q256", INFO(0x20ba19, 0x0, 64 * 1024, 512, RD_FULL | > WR_QPP | SECT_4K) }, > - {"n25q256a", INFO(0x20bb19, 0x0, 64 * 1024, 512, RD_FULL | > WR_QPP | SECT_4K) }, > + {"n25q256", INFO(0x20ba19, 0x0, 64 * 1024, 512, RD_FULL | > WR_QPP | E_FSR | SECT_4K) }, > + {"n25q256a", INFO(0x20bb19, 0x0, 64 * 1024, 512, RD_FULL | > WR_QPP | E_FSR | SECT_4K) },
FSR is required to poll flag status instead of read status only from Micron n25q512 because 512 is divided into two 256 dies so FSR is used for polling each die. In case of n25q256 the flash is single entity (doesn't have die concept) so there is no need to poll FSR. This is what I understood when I add initial FSR support 0f6232801cee4f45dbdb0cec45f71172c9b617ca Jagan. -- Jagan Teki Free Software Engineer | www.openedev.com U-Boot, Linux | Upstream Maintainer Hyderabad, India. _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
