On 08/13/2018 09:33 AM, Simon Goldschmidt wrote: > gd->env_addr points to pre-relocation address even after > relocation. This leads to an abort in env_callback_init > when loading the environment. > > Fix this by enabling CONFIG_SYS_EXTRA_ENV_RELOC.
Doesn't this apply to gen10 too ? > Signed-off-by: Simon Goldschmidt <[email protected]> > --- > > Changes in v3: this patch is new in v3 > Changes in v2: None > > include/configs/socfpga_common.h | 8 ++++++++ > 1 file changed, 8 insertions(+) > > diff --git a/include/configs/socfpga_common.h > b/include/configs/socfpga_common.h > index 8ebf6b85fe..2fb207c86a 100644 > --- a/include/configs/socfpga_common.h > +++ b/include/configs/socfpga_common.h > @@ -284,6 +284,14 @@ unsigned int cm_get_qspi_controller_clk_hz(void); > #define CONFIG_SPL_STACK CONFIG_SYS_SPL_MALLOC_START > #endif > > +#ifdef CONFIG_TARGET_SOCFPGA_GEN5 > +/* When U-Boot is started from FPGA, prevent gd->env_addr to point into > + * FPGA OnChip RAM after relocation > + */ > +#define CONFIG_SYS_EXTRA_ENV_RELOC > +#define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE /* start of > monitor */ > +#endif > + > /* Extra Environment */ > #ifndef CONFIG_SPL_BUILD > > -- Best regards, Marek Vasut _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
