On Wed, Feb 13, 2019 at 6:51 AM André Przywara <[email protected]> wrote: > > On 09/02/2019 13:14, Jagan Teki wrote: > > Add A31 spi controller support for existing sun4i_spi driver via driver > > data, this would simply add A31 register along with proper register bits > > via enum sets. > > > > Signed-off-by: Jagan Teki <[email protected]> > > --- > > drivers/spi/Kconfig | 4 +- > > drivers/spi/sun4i_spi.c | 84 ++++++++++++++++++++++++++++++++++++++++- > > 2 files changed, 85 insertions(+), 3 deletions(-) > > > > diff --git a/drivers/spi/Kconfig b/drivers/spi/Kconfig > > index ac7fbab841..15207d23c1 100644 > > --- a/drivers/spi/Kconfig > > +++ b/drivers/spi/Kconfig > > @@ -223,9 +223,9 @@ config STM32_QSPI > > this ST IP core. > > > > config SUN4I_SPI > > - bool "Allwinner A10 SoCs SPI controller" > > + bool "Allwinner A10/A31 SoCs SPI controller" > > help > > - SPI driver for Allwinner sun4i, sun5i and sun7i SoCs > > + This enables using the SPI controller on the Allwinner A10/A31 SoCs. > > > > config TEGRA114_SPI > > bool "nVidia Tegra114 SPI driver" > > diff --git a/drivers/spi/sun4i_spi.c b/drivers/spi/sun4i_spi.c > > index aeed68764c..36f2215f7d 100644 > > --- a/drivers/spi/sun4i_spi.c > > +++ b/drivers/spi/sun4i_spi.c > > @@ -24,6 +24,7 @@ > > #include <spi.h> > > #include <errno.h> > > #include <fdt_support.h> > > +#include <reset.h> > > #include <wait_bit.h> > > > > #include <asm/bitops.h> > > @@ -84,6 +85,18 @@ > > #define SUN4I_FIFO_STA_TF_CNT_MASK 0x7f > > #define SUN4I_FIFO_STA_TF_CNT_BITS 16 > > > > +/* sun6i spi registers */ > > +#define SUN6I_GBL_CTL_REG 0x04 > > +#define SUN6I_TFR_CTL_REG 0x08 > > +#define SUN6I_FIFO_CTL_REG 0x18 > > +#define SUN6I_FIFO_STA_REG 0x1c > > +#define SUN6I_CLK_CTL_REG 0x24 > > +#define SUN6I_BURST_CNT_REG 0x30 > > +#define SUN6I_XMIT_CNT_REG 0x34 > > +#define SUN6I_BURST_CTL_REG 0x38 > > +#define SUN6I_TXDATA_REG 0x200 > > +#define SUN6I_RXDATA_REG 0x300 > > + > > #define SUN4I_SPI_MAX_RATE 24000000 > > #define SUN4I_SPI_MIN_RATE 3000 > > #define SUN4I_SPI_DEFAULT_RATE 1000000 > > @@ -106,6 +119,7 @@ enum sun4i_spi_regs { > > /* sun spi register bits */ > > enum sun4i_spi_bits { > > SPI_GCR_TP, > > + SPI_GCR_SRST, > > SPI_TCR_CPHA, > > SPI_TCR_CPOL, > > SPI_TCR_CS_ACTIVE_LOW, > > @@ -133,6 +147,7 @@ struct sun4i_spi_platdata { > > struct sun4i_spi_priv { > > struct sun4i_spi_variant *variant; > > struct clk clk_ahb, clk_mod; > > + struct reset_ctl reset; > > u32 base_addr; > > u32 freq; > > u32 mode; > > @@ -255,7 +270,10 @@ static int sun4i_spi_parse_pins(struct udevice *dev) > > if (pin < 0) > > break; > > > > - sunxi_gpio_set_cfgpin(pin, SUNXI_GPC_SPI0); > > + if (IS_ENABLED(CONFIG_MACH_SUN50I)) > > + sunxi_gpio_set_cfgpin(pin, SUN50I_GPC_SPI0); > > + else > > + sunxi_gpio_set_cfgpin(pin, SUNXI_GPC_SPI0); > > sunxi_gpio_set_drv(pin, drive); > > sunxi_gpio_set_pull(pin, pull); > > } > > @@ -271,6 +289,8 @@ static inline int sun4i_spi_set_clock(struct udevice > > *dev, bool enable) > > if (!enable) { > > clk_disable(&priv->clk_ahb); > > clk_disable(&priv->clk_mod); > > + if (reset_valid(&priv->reset)) > > + reset_assert(&priv->reset); > > return 0; > > } > > > > @@ -286,8 +306,18 @@ static inline int sun4i_spi_set_clock(struct udevice > > *dev, bool enable) > > goto err_ahb; > > } > > > > + if (reset_valid(&priv->reset)) { > > + ret = reset_deassert(&priv->reset); > > + if (ret) { > > + dev_err(dev, "failed to deassert reset\n"); > > + goto err_mod; > > + } > > + } > > + > > return 0; > > > > +err_mod: > > + clk_disable(&priv->clk_mod); > > err_ahb: > > clk_disable(&priv->clk_ahb); > > return ret; > > @@ -328,6 +358,12 @@ static int sun4i_spi_probe(struct udevice *bus) > > return ret; > > } > > > > + ret = reset_get_by_index(bus, 0, &priv->reset); > > + if (ret && ret != -ENOENT) { > > + dev_err(dev, "failed to get reset\n"); > > + return ret; > > + } > > + > > sun4i_spi_parse_pins(bus); > > > > priv->variant = plat->variant; > > @@ -351,6 +387,10 @@ static int sun4i_spi_claim_bus(struct udevice *dev) > > SUN4I_CTL_ENABLE | SUN4I_CTL_MASTER | > > variant->bits[SPI_GCR_TP]); > > > > + if (IS_ENABLED(CONFIG_SUNXI_GEN_SUN6I)) > > + setbits_le32(priv->base_addr + variant->regs[SPI_GCR], > > + variant->bits[SPI_GCR_SRST]); > > + > > Just a note: This makes the driver only support one class of device, set > at compile time. Which means we could have used an #ifdef approach from > the beginning .... > Can you make this dependent on some bits in variant? That should solve it.
Yes, we can do this meaningfully via driverdata or compatible check. _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
