On Thu, May 16, 2019 at 10:10 PM Baruch Siach <[email protected]> wrote: > > Document the main U-Boot image offset when booting from SATA disk on the > Clearfog board. > > Signed-off-by: Baruch Siach <[email protected]>
Reviewed-by: Chris Packham <[email protected]> > --- > board/solidrun/clearfog/README | 6 ++++++ > 1 file changed, 6 insertions(+) > > diff --git a/board/solidrun/clearfog/README b/board/solidrun/clearfog/README > index 0b0e98de90a0..6171ce66f4f8 100644 > --- a/board/solidrun/clearfog/README > +++ b/board/solidrun/clearfog/README > @@ -40,6 +40,12 @@ Install U-Boot on eMMC boot partition from Linux running > on Clearfog: > Note that the SD card is not accessible when the Clearfog SOM has eMMC. > Consider initial boot from UART (see below). > > +Install U-Boot on SATA: > +----------------------- > + > +When loading the main U-Boot image from raw SATA sector, set > +CONFIG_SPL_SATA_RAW_U_BOOT_SECTOR to 0x141. > + > Boot selection: > --------------- > > -- > 2.20.1 > > _______________________________________________ > U-Boot mailing list > [email protected] > https://lists.denx.de/listinfo/u-boot _______________________________________________ U-Boot mailing list [email protected] https://lists.denx.de/listinfo/u-boot
